Drop IP/ASI output on input loss

Drop IP/ASI output on input loss

MK.IO Beam can be configured to drop IP/ASI output on input loss. This can be configured for Live Encoder + Multiplexer feed templates.

To configure this, follow these steps:

  1. For the Live Encoder:

    1. Go to the feed card then edit the Live Encoder by clicking next to the LIVE ENCODER component within the feed.

    2. Click the Output tab then click to edit the output.

    3. In the Common MPEG-2 TS Parameters section, set the Signal loss management to Drop transport stream.

  2. For the corresponding Multiplexer:

    1. Go to the feed card then edit the Multiplexer by clicking next to the MULTIPLEXER component within the feed.

    2. From the Stream Processing tab, click Output stream > Service (x).

    3. Go to the Properties > Sources sub-tab then tick the Output Drop On Input TS Loss checkbox.